QLN SONORA *To Order
- Due to the specificity of the product, it is not available for sale online
- If you want to buy, please contact Carlos Moreira
Tel.: 917 230 062
A new era in the history of QLN. QLN Sonora Floorstanding Speakers with fullrange driver and additional tweeter, work perfectly with low power amplifiers - 5W and above. QLN Sonora Floorstanding Speakers have highly sensitive speakers with classic design and the latest driver technology. Focused on low distortion technology and without resonance. The aim is to produce a simple, easy to hear sound that responds well to the smallest input signal. Time alignment drivers, silent and non-resonant speakers that do not add color to the music. Drive units with extremely light cones that offer high sensitivity to easily connect to low-powered amplifiers. With a low cone mass, they did not penetrate deeply into the smaller boxes, so they produced a larger box. Thus, we have natural uncompressed bass, sharp and deep with high sensitivity.
The elegant design of the QLN Sonora Floorstanding Speakers is on the inside. Sonora QLNs share the same DNA with other QLN Speakers. However, they did it in a different way.
The cabinet is tuned to make a natural roll-off without any ringing in step response. Cabinet are made of 19mm thick HDF-board with internal damping pads for minimising cabinet material resonances. Cabinet is heavily braced to give stiff cabinet and the damping pads make in non resonant so the cabinet don’t store sound in the time domain. Natural wool is used for internal acoustic damping because it sond best and have a wider frequency damping of the internal sound. It is loose packed so we don’t store sound in the damping material. We use minimum damping material and apply it where it do the most use, in centre and middle of the cabinet there air speed is at it maximum. Then we can apply minimum damping material to achieve maximum damping of the internal sound.
The 1,5 way crossover with it minimum number of components is hardwired with high-end Mundorf capacitors and baked air coils to avoid any internal component and filter resonances. The result is perfect timing within the crossover and throughout the entire frequency range.
The 8” fullrange and treble drivers have been specifically selected and custom developed by industry renowned driver manufacturers and offer the latest in 21st century advanced driver technology. The unique light weight 8” fullregister driver with its built-in copper rings in the magnet system offers symmetric drive suppressing intermodulation distortion. Low losses and large window in the chassis to reduce reflection air noice resulting in industry leading high-end voice handling and astonishing micro/macro dynamics in its hole frequency range. Likewise the 30mm wide surround waveguide tweeter offers time alignment superb vocal rendition and excellent imaging at all listening positions. Large roll surround, built-in copper ring and textile dome diaphragm provides a flat frequency response above 30 KHz. Large rear acoustic chamber give low compression and move tweeter system resonance far from crossover point. The level is a few dB lower that the 8” full range driver and just ass little extra details, resolution and dispersion over 10k to assist the full range driver.
CABLES AND SPEAKER CONNECTORS
Internal cabling are our own special design cable. Special designed for use as internal speaker cable . All components are carefully hand selected and individually tested for any deviances. WBT pure copper NexgenTM pole screws are used with grip-friendly screws.
- Impedance: 8 ohms
- Amplifier requirements: 5-100 Watt RMS
- Tweeter: 30mm wave guide, wide surround, soft dome
- Woofer: 200mm fullrange, light weight cone
- Sensitivity: 92 dB SPL 1 Watt 1m
- Low frequency performance: -3dB 35Hz
- Cabinet: 19mm with Qboard® philosophy design
- Terminal: WBT Single wire
- Dimensions (HxWxD): 1020x250x300
- Weight: 29,0 k
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.